VINNY'S NEW YORK PIZZA & GRILL

Observed accumulated mold debris inside the ice machine. Equipment Food-Contact Surfaces and Utensils. Equipment food-contact surfaces and utensils shall be clean to sight and touch. PIC to drain, wash, rinse and sanitize the ice machine at COB.

Observed several cold held food items to be uncovered. Storing the food in packages, covered containers, or wrappings, except for loosely covered or uncovered containers in which food is being cooled if protected from overhead contamination. COS: PIC voluntarily covered all food items during inspection.

Observed cooked chicken, sliced ham, and sliced turkey cooling while fully covered. Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled: (i) Placing the food in shallow pans; Pf (ii) Separating the food into smaller or thinner portions; Pf (iii) Using rapid cooling equipment; Pf (iv) Stirring the food in a container placed in an ice water bath; Pf (v) Using containers that facilitate heat transfer; Pf (vi) Adding ice as an ingredient; Pf or (vii) Other effective methods. Note: PIC voluntarily placed sliced turkey, sliced ham, and cooked chicken into an ice bath during the inspection.

Accumulated mold debris was observed inside the ice machine. 511-6-1.05(7)(b) - Food Contact Surfaces and Utensils - Cleaning Frequency (P, C) (b) Equipment Food-Contact Surfaces and Utensils. 1. Equipment food-contact surfaces and utensils shall be cleaned: Note: Manager will clean the ice machine at the end of the day.

Observed cooked chicken cooling in 4 plastic containers in the walk in cooler covered with food depths more than 3 inches. 511-6-1.04(6)(e) - Cooling Methods (Pf, C) (e) Cooling Methods. 1. Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled: (i) Placing the food in shallow pans; Pf (ii) Separating the food into smaller or thinner portions; Pf (iii) Using rapid cooling equipment; Pf (iv) Stirring the food in a container placed in an ice water bath; Pf (v) Using containers that facilitate heat transfer; Pf (vi) Adding ice as an ingredient; Pf or (vii) Other effective methods. Pf 2. When placed in cooling or cold holding equipment, food containers in which food is being cooled shall be: (i) Arranged in the equipment to provide maximum heat transfer through the container walls; and (ii) Loosely covered, or uncovered if protected from overhead contamination during the cooling period to facilitate heat transfer from the surface of the food. Note: Chicken was transfered to new containers with food depth of 3 inches, uncovered and placed in ice baths during the inspection.

Observed (3) sanitizing buckets and spray registering 0 ppm of QAC. COS: All buckets and spray sanitizers were remade to 200 ppm of QAC. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions. Note: PIC immediately remade all sanitation buckets.