Georgia › Franklin County › Royston
SUBWAY SANDWICH SHOP
40 FRANKLIN SPRINGS CIR , ROYSTON, GA 30662 · Health inspection record from Georgia Department of Public Health
Most recent inspection (August 4, 2026): no individual violations are recorded in the published data.
Inspection history
Every recorded inspection, newest first. Open one to see what the inspector found that day — a past failure matters even when the current score looks fine.
A100August 4, 2026No violations recorded
No individual violations are recorded for this inspection in the published data.
A96February 16, 20261 violation
Inspectors recorded 1 violation, 1 of them critical, involving temperature control.
Observed no ambient thermometer in the WIF or WIC. Instructed PIC to place thermometers in the WIF & WIC. Rule: 511-6-1.05(2)(x) - TMD, Located in Refrigerators/ Hot Holding (Pf, C) (x) Temperature Measuring Devices. 1. In a mechanically refrigerated or hot food storage unit, the sensor of a temperature measuring device shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot food storage unit.
−3 points · Cited as “511-6-1.05(2)(x) - tmd, located in refrigerators/ hot holding (pf, c)”A96August 29, 20251 violation
Inspectors recorded 1 violation, 1 of them critical, involving temperature control.
Observed no ambient thermometer in the WIF or WIC. Instructed PIC to place thermometers in the WIF & WIC. Rule: 511-6-1.05(2)(x) - TMD, Located in Refrigerators/ Hot Holding (Pf, C) (x) Temperature Measuring Devices. 1. In a mechanically refrigerated or hot food storage unit, the sensor of a temperature measuring device shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot food storage unit.
−3 points · Cited as “511-6-1.05(2)(x) - tmd, located in refrigerators/ hot holding (pf, c)”A91February 18, 20254 violations
Inspectors recorded 4 violations, 3 of them critical, involving cleaning & sanitizing, temperature control and garbage & waste.
Observed sanitizer to have a concentration of 0ppm QUAT at beginning of inspection. PIC COS by remaking new sanitizer that read at 200ppm QUAT.
−4 points · Cited as “511-6-1.05(6)(n) - manual and mechanical warewashing equipment, chemical sanitization-temperature, ph, concentration, hardness (p,pf)”Observed meat slicer, microwave, and drink machine not cleaned to sight and touch. PIC instructed to clean and sanitize deli slicer per manufacturers instructions. PIC instructed to clean microwave to sight and touch. PIC instructed to clean nozzles of drink machine in sanitizer and clean table that drink machine is on to sight and touch.
−4 points · Cited as “511-6-1.05(7)(a)1 - equipment, food-contact surfaces,& utensils (pf)”Observed ambient thermometer in WIC to not be working. No ambient thermometer was observed in WIF. PIC to replace ambient thermometers.
−3 points · Cited as “511-6-1.05(2)(x) - tmd, located in refrigerators/ hot holding (pf, c)”Drain plug missing from dumpster. PIC informed contact their waste management company for a replacement.
−1 point · Cited as “511-6-1.06(5)(o),(p) - using drain plugs; maintaining refuse areas (c)”A94August 15, 20242 violations
Inspectors recorded 2 violations involving pest control and garbage & waste.
511-6-1.07(2)(k) - Insect Control Devices (C) (k) Insect Control Devices, Design and Installation. 1. Insect control devices that are used to electrocute or stun flying insects shall be designed to retain the insect within the device. 2. Insect control devices shall be installed so that: (i) The devices are not located over a food preparation area; and (ii) Dead insects and insect fragments are prevented from contact with exposed food; clean equipment, utensils, and linens; and unwrapped single-service and single-use articles. Note: Fly strip handing over 3-Compartment sink. PIC removed fly strip from area.
−3 points · Cited as “511-6-1.07(2)(k) - insect control devices (c)”511-6-1.06(5)(o),(p) - Using Drain Plugs; Maintaining Refuse Areas (C) (o) Using Drain Plugs. Drains in receptacles and waste handling units for refuse, recyclables, and returnables shall have drain plugs in place. (p) Maintaining Refuse Areas and Enclosures. A storage area and enclosure for refuse, recyclables, or returnables shall be maintained free of unnecessary items and clean. Note: Drain plug missing from dumpster. PIC stated they would contact their waste management company for a replacement.
−1 point · Cited as “511-6-1.06(5)(o),(p) - using drain plugs; maintaining refuse areas (c)”A95January 31, 20242 violations
Inspectors recorded 2 violations involving pest control.
Fly Strip hanging next to back door and above archway between the front food service area and prep food area. Insect control devices may not be located over food prep areas insect parts could fall and contaminate areas, items and/or food. Work with pest control operator and health authority for hygienic and effective methods of pest control..07(2)(m) Back door to outside is not self closing. Outer openings must be solid, self closing and tight fitting. Fix door such that it is self closing and shuts completely to be tight fitting.
−3 points · Cited as “511-6-1.07(2)(k) - insect control devices (c)”Dumpster lids left open. Dumpster lids need to be closed when not in use to prevent the attraction of pests and insects. .06(5)(o)(p) Dumpster missing drain plugs. Receptacles with drains must have drain plugs in place.
−1 point · Cited as “511-6-1.06(5)(n) - covering receptacles (c)”Georgia scores on a 100-point scale: A 90–100, B 80–89, C 70–79, U below 70.
Source
Published by the Georgia Department of Public Health · permit S-059-020. Verify this record at ga.healthinspections.us. Georgia’s inspection records are published by county health district, not from a single statewide portal.